Question 4
part A(2300 words)
Perform a Taguchi experiment (within a DMAIC improvement cycle) on the standard design of paper aeroplane (attached) to optimise a suitable quality characteristic. Analyse the data from the experiment and conclude on the design, predicting the results from your optimised design and confirm that your experiment has been successful. Comment on the results of your confirmation. In doing so;
(i) Explain your choice of quality characteristic.
(ii) Define control and noise factors that you would include. Explain your choices.
(iii) Prepare an experimental design and carry it out, detailing how it was performed.
(iv) Indicate how you analysed the results. What conclusions did you draw? What would you do if the results you expected were not confirmed?
At all stages clearly explain what you did and your reasons for adopting the approach that you did.
Section B: Reflective writing
Write a short reflection on your learning from the PIUSS module. This should be no more than 500 words and should be submitted with the PMA.( please see uploading for more info)
MODULE TITLE
Table of Contents
1 Heading 1 – Suggested that you use this for each Question answered 6
1.1 Heading 2 – suggested that you use this for each sub-heading in each question answered 6
1.1.1 Heading 3 – you may use this heading as appropriate 6
Enter a page break here and between each question
1Heading 1 – Suggested that you use this for each Question answered
1.1Heading 2 – suggested that you use this for each sub-heading in each question answered
1.1.1Heading 3 – you may use this heading as appropriate
Use the order calculator below and get started! Contact our live support team for any assistance or inquiry.
[order_calculator]